FAQ
INSTRUCTIONS ON HOW TO USE OUR UVDTF TRANSFERS:
DO NOT USE ALCOHOL TO CLEAN THE SURFACE WHERE YOU WILL PLACE THE UVDTF TRANSFER, IF YOU NEED TO CLEAN THE SURFACE JUST USE SOAP AND WATER AND AIR DRY ONLY
DO NOT USE ALCOHOL TO CLEAN THE SURFACE WHERE YOU WILL PLACE THE UVDTF TRANSFER, IF YOU NEED TO CLEAN THE SURFACE JUST USE SOAP AND WATER AND AIR DRY ONLY
- Cut the excess from the edges of the transfer (make sure not to cut the design).
- Scrape the front and back of the design with a Vinyl squeegee tool using firm pressure to ensure that the design adheres perfectly well to the transparent transfer film.Keep the transfer as flat as possible at all times, if the transfer bends or is not handled carefully it will break.
- With your transfer FACING DOWN remove the white or transparent backing film starting with one corner and roll the backing off of the transfer little by little, DO NOT pull apart from both sides of the transfer.(If you performed Step #2 correctly the entire design should be adhered to the film with glue when completing Step #3, otherwise repeat from Step #2.)
- Place your design on your cup or surface of preference WITHOUT OVER BENDING THE TRANSFER, remember that UVDTF transfers CAN'T be rearranged once they have adhered to the cup.
- Scrape/Squeegee over the transfer very well and with firm pressure before removing the film, taking special care for the thin or small details of the design, this step is very important since it ensures that the transfer adheres very well to the cup.
- Remove the film starting from one corner and do it slowly and in small parts, If the film is removed too quickly or pulled with force the transfer may break.
Wait at least 24 hours before to wash or wet the cup.